Filter
Top Products
Inputs & Outputs 23
01V—Owner’s Manual
D STEREO OUT
These are balanced XLR-3-32-type
connectors with a +4 dB nominal
output level. They are wired pin
1–ground, pin 2–hot (+), and pin
3–cold (–). They output the main ste-
reo mix.
If you need to connect the balanced ST OUT to an unbalanced phone jack input, use a
cable with the following wiring scheme (i.e., XLR pins 3 and 1 linked).
E DIGITAL STEREO OUT
This phono jack outputs the main stereo mix as Coaxial format 24-bit digital audio,
allowing digital transfer to a DAT, MiniDisc deck, or other digital recorder.
F DIGITAL STEREO IN
This phono jack accepts 24-bit Coaxial format digital audio. Signals input here can be
fed directly to the Stereo bus for stereo cascade operation (i.e., two mixers working
together), or to input channels 13 and 14.
G MIDI IN, OUT, THRU
These are standard MIDI IN, OUT, and THRU ports and are used to connect the 01V
to other MIDI equipment for remote control and data backup. The MIDI IN port
receives MIDI messages, while the MIDI OUT port transmits them. The MIDI THRU
port transmits all MIDI messages received at the MIDI IN port.
H TO HOST
This 8-pin mini DIN port is used to connect the 01V to a personal computer for use
with MIDI software. It eliminates the need for a computer MIDI interface, and together
with the MIDI ports allows the 01V to be used as a MIDI interface for other MIDI
equipment.
I POWER switch
This switch is used to turn on and off the 01V. It’s recessed to prevent accidental oper-
ation.
J OPTION I/O slot
An Option I/O card can be installed here, providing access to the 01V’s eight digital
inputs and outputs. See “About Option I/O Cards” on page 216.
Female XLR plug
1 (ground)
3 (cold)
2 (hot)
Female XLR plug
1 (ground)
3 (cold)
2 (hot)
1/4" phone plug
Tip (hot)
Sleeve (ground)