Send Ctrl-D Before Each Job
This control specifies whether the product will be reset at the beginning of every postscript
document. The default setting is No. Ctrl-D resets the product to its default setting to ensure that
previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail if the
product is connected through a network. If your document fails to print when sent to a product
connected through parallel or serial ports, change No to Yes.
Send Ctrl-D After Each Job
This control specifies whether the product will be reset at the end of every postscript
document. The default setting is Yes. Ctrl-D resets the product to its default setting to ensure
that future print jobs are not affected by the current print job. Ctrl-D might cause a print job to
fail if the product is connected through a network. If your document fails to print when sent to
a network printer, change Yes to No.
Job Timeout
This control specifies how long the document can take to get from the computer to the
product before the product stops trying to print the document. If you specify 0 seconds, the
product continues trying to print indefinitely. The default setting is 0 seconds. You can use
the spin box to change this value to a maximum of 32,767 seconds.
Wait Timeout
This control specifies how long the product waits to get more postscript information from the
computer. After the specified time passes, the product stops trying to print the document and
prints an error message. If you are trying to print a very complicated document, you might
want to increase this value. If you specify 0 seconds, the product waits indefinitely. The
default setting is 300 seconds. You can use the spin box to change this value to a
maximum of 32,767 seconds.
Minimum Font Size to Download as Outline
This control specifies the minimum font size (in pixels) for which the postscript driver
downloads TrueType fonts as outline (Type 1) fonts. A font smaller than the minimum setting
is downloaded as a bitmap (Type 3) font. Use this option to fine-tune the Automatic setting
for the TrueType Font Download option on the Advanced tab in Document Defaults. The
default setting is 100 pixels. You can use the spin box to change this value to a maximum of
32,767 pixels.
Maximum Font Size to Download as Outline
This control specifies the maximum font size (in pixels) for which the postscript driver will
download TrueType fonts as bitmap (Type 3) fonts. A font larger than the maximum setting
will be downloaded as an outline (Type 1) font. Use this option to fine-tune the Automatic
setting or override the Send TrueType as Bitmap setting for the TrueType Font Download
option on the Advanced tab in Document Defaults. The default setting is 600 pixels. You
can use the spin box to change this value to a maximum of 32,767 pixels.
Installable Options
This section provides information to configure the printing options that you can install for the
HP Color LaserJet 4650 printer. The following controls are available:
● Tray 3
● Tray 4
● Duplex Unit (for 2-sided Printing)
EN Chapter 3 HP traditional print drivers for Windows 147
