Back Cover
The following illustration shows the Back Cover setting and options.
Figure 4-7.
Back Cover setting
The Back Cover options are as follows
● Add a blank back cover check box
● Source is: drop-down menu
● Type is: drop-down menu
When you select Back Cover, you must also select the Add a blank back cover check box
to enable the setting. When you select this check box, the Source is: and Type is: drop-
down menus become available and a check mark appears next to the Back Cover option.
The Back Cover options are not available when the Booklet Printing Layout setting is
enabled on the Finishing tab. The back cover setting is unavailable, because this page
would otherwise be printed in the middle of a booklet.
The Source is: setting specifies the source tray to use for adding a back cover to the
document. The list of source trays depends on the printer accessories. Any optional media
trays that are installed through the Device Settings tab also appear here. For more
information about the Source is: setting, see the
Source Is section of this chapter.
The Type is: drop-down menu shows all of the media types that the printer supports. For
more information about the Type is: drop-down menu settings, see the Type is: in the
Type is
section of this chapter.
Note
EN Chapter 4 HP PCL 6, HP PCL 5c, and HP PS 3 emulation unidrivers for Windows 169
