3
Type FTP <TCP/IP printer ADDRESS> For example, if the TCP/IP address is
192.168.0.90, type FTP 192.168.0.90
4 Press Enter on the keyboard.
5 When prompted for a user name and password, press Enter.
6
Type
put <path>, where <path> is the location where
the .RFU file was downloaded fromthe Web, including the path. For example, type put /username/desktop/4650fw.rfu
and then press Enter.
If the file name or path includes a space, you must enclose the file name or path in quotation
marks. For example, type put "/user name/desktop/4650FW.RFU".
To ensure that the entire path to the .RFU file is placed in the put command, type put and a
space, and then drag and drop the .RFU file onto the terminal window. The complete path to the
file is automatically placed after the put command.
7 The download process begins and the firmware is updated on the product. This can take
about five minutes. Let the process finish without further interaction with the product or
computer.
The product automatically turns off and then on again to activate the update. At the end of the
update process, the READY message appears on the control panel.
Remote firmware update through a local Windows port
If the product is connected through a local port (parallel), then you can send the .RFU file directly
to the product by using a COPY command from a command prompt or an MS-DOS window. At
the command prompt, perform the following steps for your operating system.
Windows 98 or Windows Me
1 From a command prompt or in an MS-DOS window, type:
Mode lpt1:,,p
If the product is attached to a parallel port other than LPT1, then substitute the correct LPT port
number in the mode command.
2 Press Enter on the keyboard. The response that you receive should be similar to these
examples:
> LPT1 Not Rerouted
> Resident portion of MODE loaded
> Infinite retry on parallel printer time-out
3
At a command prompt, type copy/b <FILENAME> <PORTNAME>, where <FILENAME> is
the name of the .RFU file (including the path) and <PORTNAME> is the name of the
appropriate product port (such as LPT1). For example, C:\>copy/b c:\4650fw.rfu
lpt1
If the file name or path includes a space, you must enclose the file name or path in quotation
marks. For example, type C:\>copy/b "c:\My Documents\4650fw.rfu" lpt1
4 Press Enter on the keyboard. The messages that are described in the section Printer
messages during the firmware update appear on the control panel.
The product automatically turns off and then on again to activate the update. At the end of the
update process, the READY message appears on the control panel.
Note
Note
Note
Note
Note
48 Remote firmware update EN
