● Garamond Halbfett
● Univers Condensed Bold Italic
● CG Omega
● Garamond Kursiv
● Univers Condensed Medium
● CG Omega Bold
● Garamond Kursiv Halbfett
● Univers Condensed Medium Italic
● CG Omega Bold Italic
● Letter Gothic
● Univers Medium
● CG Omega Italic
● Letter Gothic Bold
● Univers Medium Italic
● CG Times
● Letter Gothic Italic
● Univers Italic
● CG Times Bold
● CG Times Bold Italic
● Wingdings
● CG Times Bold Italic
Installing the Macintosh printing system
On a Macintosh-compatible computer, the installation procedures are the same for a network
administrator, a network client, and a single user. Install the software on any computer that has
access rights to the printer.
If the computer is connected to the printer by a LocalTalk (printer port) or EtherTalk connection,
you must configure the AppleTalk (or network) control panel for the correct connection to
communicate with the product. You must set up the HP Color LaserJet 4650, connect it to the
computer or network, and turn it on before the software is installed. Macintosh OS systems do
not support parallel connections. You can use a cross-over Ethernet cable for a direct
connection to a computer running the Macintosh OS. In the following instructions, "XXXX"
represents the HP Color LaserJet 4650:
The Macintosh partition contains an installer program for each language. Find the appropriate
language for the operating system that is being used, and then use the installer program for that
language.
Note
262 Installing the Macintosh printing system EN
