A SERVICE OF

logo

Figure 5-15.
Set Network Communication Mode dialog box
Clicking Change Settings... takes you to the Change Settings dialog box, where you can type
a different IP Address, Subnet Mask, and Gateway address. Clicking OK returns you to the Set
Network Communications dialog box.
Clicking Next takes you to the Model dialog box or the Network Configuration Complete
dialog box, depending on your previous selections.
Clicking Back returns you to the Select Port dialog box when you are performing a direct
connection installation, or to the Set Network Communication Mode dialog box when you are
performing a network installation.
Clicking Cancel takes you to the Exit Setup dialog box.
226 Detailed Windows installation EN