Filter
Top Products
Windows
Requirements
To use the UDK in own projects, the following is required:
• Installed drivers
• Microsoft Visual Studio 2005 or 2008; 2010 is experimental
• CMake 2.6 or higher ⇒ http://www.cmake.org
• wxWidgets 2.8.10 or higher (must be build separately) ⇒ http://www.wxwidgets.org
[optionally, only if UDKLab should be build]
Driver installation
The driver installation is part of the UDK installation but can run standalone on final
customer machines without the need to install the UDK itself. During installation, a choice
of drivers to install can be made, so it is not necessary to install i.e. PCI drivers on
machines that should run USB devices only or vice versa. If USB drivers get installed on a
machine that has a pre-2.0 UDK driver installation, we prefer the option for USB driver
cleanup offered by the installer, this cleanly removes all dependencies of the old driver
installation.
Note: There are separate installers for 32 and 64 bit systems.
Important: At least one device should be present when installing the drivers !
Build UDK
Prerequisites
The most components of the UDK are part of one large CMake project. There are some
options that need to be fixed in msvc.cmake inside the UDK installation root:
• BUILD_UI_TOOLS If 0, UDKLab will not be part of the subsequent build procedure, if 1 it
will. This requires an installation of an already built wxWidgets.
• WX_WIDGETS_BASE_PATH Path to wxWidgets build root, only needed if
BUILD_UI_TOOLS is not 0.
• USE_STATIC_RTL If 0, all projects are build against the dynamic runtime libraries. This
requires the installation of the appropriate Visual Studio redistributable pack on every
machine the UDK is used on. Using a static build does not create such dependencies,
but will conflict with the standard wxWidgets build configuration.
Solution creation and build
The preferred way is to open a command prompt inside the installation root of the UDK,
USBS6 / C1030-5510 http://www.cesys.com/
User Doc V0.3 -31- preliminary