Filter
Top Products
17
Switching Between A Bus and B Bus
3. Move the video fader.
Move the video fader. Moving it toward the back of the unit makes more of the picture on A Bus appear, and moving
toward the front displays more B Bus picture.
*If you selected [CUT] in step 2, the picture is switched between A Bus and B Bus at the middle position of the video fader.
*When the same input channel has been selected for A Bus and B Bus, moving the video fader does not affect the output.
fig.move-Tbar.eps
When the video fader has not been moved all the way to the A Bus or B Bus side, changing the input channel for the opposite bus may
cause noise on the output picture. When changing the input channel for the bus on the side opposite the bus displayed, first make sure
that the video fader has been moved all the way to the end of the stroke.
The LEDs of the Input Selector Buttons
Pressing an input selector button for A Bus or B Bus makes the button’s LED light up. The color of the LED may change
to red or green, depending on the position of the video fader. The LED at the end of the stroke to which the video fader
has been moved completely (100% output) lights up in red, and the LED at the opposite end of the stroke (corresponding
to the channel now in standby and providing no output at all) lights up in green. When the control is not completely at
one of these ends, and both buses are producing output, both LEDs light up in red.
Red
Green
Red
Green
Red
Red