Filter
Top Products
22
Changing the Volume to Add
Expression ( VOLUME)
1. Press the [VOLUME] button so it’s lit.
2. While playing the keyboard, position your hand
over the D beam controller, then move it up and
down.
The volume will change, allowing you to add expression to
your performance.
If you press the [VOLUME] button once again, it will blink;
now sound will be produced when you move your hand
above the D BEAM controller.
Press the [VOLUME] button to turn o its illumination; the
D BEAM will turn o .
Holding Notes After Removing
Your Hand from the Keyboard
( KEY HOLD)
You can make notes continue sounding even after you
take your hand o the keyboard.
1. Press the [KEY HOLD] button so it’s lit; key hold
will be turned on.
When you play a new key, the previously sounding note
will stop sounding, and only the newly played note will be
heard.
If the arpeggiator is on, turning key hold on will cause the
arpeggio to continue sounding.
Automatically Playing Arpeggios
( ARPEGGIO)
Press the [ARPEGGIO] button so it’s lit; the arpeggiator will
be on.
Playing an Arpeggio
1. Press the [ARPEGGIO] button so it’s lit; the
arpeggiator will be on.
Press a chord on the keyboard; an arpeggio will sound
according to the settings stored for each patch.
If you press the [KEY HOLD] button so it’s lit, the arpeggio
will continue sounding.
When you play a chord on the keyboard, an arpeggio will
be produced according to the settings stored for each
patch, and the arpeggio will continue sounding even after
you take your hand o the keyboard. When you play a
di erent chord, the notes of the arpeggio will also change.
To stop the arpeggio, turn o the arpeggiator.
To turn o the arpeggiator, press the [ARPEGGIO] button
so it goes out.