Filter
Top Products
52
Parameter Range Explanation Panel operation
PEDAL ASSIGN
This selects the function that will be controlled by a pedal connected to
the PEDAL jack.
HOLD:
The pedal will operate as a damper pedal.
MODULATION:
CC01: The pedal will have the same operation as when using the pitch
bend/modulation lever to apply MODULATION.
VOLUME:
CC07: The pedal will adjust the overall volume.
EXPRESSION:
CC11: The pedal will apply expression to your performance.
BEND MODE:
The pedal will switch the BEND MODE (STANDARD, LAST + CATCH)
STANDARD:
The pitch bend/modulation lever will operate in the conventional
way.
LAST+CATCH:
The pitch bend/modulation lever will apply only to the last-played
note (LAST).
If a note-on occurs when the pitch bend/modulation lever is already
moved to the side, that note will sound at its normal pitch (as though
the lever were at the center).
The pitch of the note will begin changing only after the lever has
moved through its center position (CATCH).
D BEAM SYNC:
The pedal will have the same operation as when D BEAM [EFFECTS/
ASSIGN] is on.
TAP TEMPO:
The pedal will have the same operation as the panel [TAP TEMPO] button.
1. Hold down the [CANCEL/SHIFT] button and press the
[V-LINK] button.
2. Hold down the [PORTAMENTO] button and press one of
the NUMBER [1]–[7] buttons.
1: HOLD
2: MODULATION
3: VOLUME
4: EXPRESSION
5: BEND MODE
6: D BEAM SYNC
7: TAP TEMPO
3. Press the [CANCEL/SHIFT] button.
CLOCK SOURCE
This species what the tempo of the arpeggiator and phrase recorder will
be synchronized to.
PATCH:
They will synchronize to the tempo saved in each patch.
SYSTEM:
They will synchronize to the common tempo (System Tempo) of the entire
SH-01.
MIDI:
They will synchronize to MIDI clock data received at the MIDI IN connector.
USB:
They will synchronize to MIDI clock data received at the USB connector.
1. Hold down the [CANCEL/SHIFT] button and press the
[V-LINK] button.
2. Hold down the LFO [TEMPO SYNC] button and press one of
the eect buttons.
[DIST] button: PATCH
[FLANGER] button: SYSTEM
[DELAY] button: MIDI
[REVERB] button: USB
3. Press the [CANCEL/SHIFT] button.
MIDI parameters
Parameter Range Explanation Panel operation
RX/TX CHANNEL 1–16
Species the MIDI channel on which the SH-01 will
transmit and receive MIDI messages.
1. Hold down the [CANCEL/SHIFT] button and press the
[V-LINK] button.
2. Hold down the [V-LINK] button and press one of the
NUMBER [1]–[8] buttons.
1–8 ([BANK] button unlit): 1–8
1–8 ([BANK] button lit): 9–16
Hold down the [V-LINK] button and press the [BANK]
button to make it light or go out.
3. Press the [CANCEL/SHIFT] button.
MIDI-USB THRU OFF, ON
If this is on, MIDI messages received at the MIDI
IN connector will be re-transmitted from the USB
connector without change.
1. Hold down the [CANCEL/SHIFT] button and press the
[V-LINK] button.
2. Hold down the OSC [VARIATION] button and press the
[EFFECTS ON/OFF] button.
Button lit: ON
Button unlit: OFF
3. Press the [CANCEL/SHIFT] button.