Filter
Top Products
55
USB Memory
The GAIA SH-01 is equipped with a USB memory connector that allows you to use USB memory as storage media.
Using USB Memory
Make sure that the USB memory is oriented correctly, and
insert it into the GAIA SH-01’s USB connector.
* Use USB memory made by Roland.
930
* Connect USB memory after you’ve powered up the GAIA
SH-01. Never disconnect USB memory while the power
is turned on.
931
* When inserting USB memory, make sure that the
connector is oriented correctly, and insert the connector
all the way in. Do not use excessive force.
[ PATCH] button
This button selects patches from USB memory.
”Selecting Sounds” (p. 18)
This button is also used to save patches you’ve created on
the GAIA SH-01.
”Saving a Sound You’ve Created (WRITE)” (p. 39)
Initializing USB Memory
Here’s how to initialize the USB memory.
NOTE
All data saved on the USB memory will be lost when you
execute this procedure.
1. Switch o the instrument’s power, then insert the
USB memory that you want to initialize into the
USB MEMORY connector.
2. While holding down both the [TONE COPY] button
and the USB MEMORY [PATCH] button, switch on
the instrument’s power.
The [TONE COPY] button and the USB MEMORY [PATCH]
button will light, and the [CANCEL/SHIFT] button and the
[WRITE] button will start blinking.
If you wish to cancel the procedure, press the [CANCEL/
SHIFT] button.
3. Press the [WRITE] button.
Initialization of the USB memory will begin.
The NUMBER buttons light in sequence, beginning with
[1]. The procedure will nish after NUMBER [8] has lighted.
Once initialization of the USB memory has been com-
pleted, you are returned to the normal mode.