Filter
Top Products
21
Setting Up the Kit
An Overview of the TD-20
When using the VH-12, the “VH Offset” needs to be set up.
1.
Loosen the clutch of the top hi-hat and let it sit
on the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
2.
Hold down [KIT] and press [TRIGGER].
The “VH offset” parameter is set automatically. (approx.
3 seconds)
[TRIGGER] stops flashing and remains lit.
fig.05-VHOffset3
If you need, make further adjustments to the parameters.
Hi-Hat Settings [F3 (HI-HAT)]
(p. 46)
If you do not make VH-12’s setting correctly, it may cause
malfunction. For details, refer to the VH-12 owner’s
manual.
Heads MUST BE TUNED BEFORE PLAYING.
When adjusting, use a tuning key.
Like with an acoustic drum, accurate and equal head tension
is needed for correct triggering response.
On the PD-125/105, adjusting the head tension affects
only the head response, and not the pitch of the sound, as
it would on an acoustic drum.
1.
Loosen the tuning bolts until a slight gap is
produced.
2.
Tighten all tuning bolts by fingers, as tightly as
you can.
fig.PD-Nut.e
3.
Using the tuning key, turn the tuning bolts two
full revolutions each, thus tightening them.
Tighten each tuning bolt one by one, observing the
numerical order shown in the figure.
fig.PD-BoltOrder
Connecting the Hi-Hat (VH-12)
and Setting the “VH Offset”
Connecting the Hi-Hat
Adjusting the Offset
CONTROL
OUTPUT
jack
TRIGGER
OUTPUT
jack
to
TRIGGER INPUT
HI-HAT jack
to
HH CTRL jack
Clutch
screw
Adjusting Mesh Head
Tension (PD-125/105)
Tuning bolt
Washer
Hoop
Slight gap
13
4
2
5
6
HEAD MADE BY REMO U.S.A.
TD-20_Ref_e.book 21 ページ ２００５年５月２５日 水曜日 午前９時４９分