Filter
Top Products
53
Chapter 6. Sequencer (Playback)
Chapter 6
[PLAY]
1.
Press [TEMPO].
2.
[TEMPO] lights, and the “TEMPO” screen
appears.
fig.06-Tempo1_70
3.
Use [+/-] or [VALUE] to select the tempo.
4.
Press [EXIT] to return to the “DRUM KIT”
screen.
You can set the tempo by hitting a pad or [PREVIEW]
two or
more times
at
quarter-note intervals
of the desired tempo.
1.
Press [TEMPO].
[TEMPO] lights, and the “TEMPO” screen appears.
2.
Press [F3 (TAP)].
The “TAP TEMPO” screen appears.
fig.06-Tempo2_70
3.
Press [CURSOR (up)] to move the cursor to
“Tap Switch.”
4.
Use [+/-] or [VALUE] to set to “ON.”
5.
Press [CURSOR (down)] to move the cursor to
“Tap Pad.”
6.
Use [+/-] or [VALUE] to select the pad (or
[PREVIEW]) to use for Tap Tempo function.
7.
Press [KIT] to return to the “DRUM KIT” screen.
When you hit the pad (or [PREVIEW] selected in the step 5,
the tempo is displayed at the upper right of the display.
fig.06-Tempo3_70
This section discusses the settings that allow an external MIDI
sequencer and the TD-20’s sequencer to be synchronized. The
device that is playing back is called the “master” and the device
that is synchronizing to the playback is called the “slave.”
1.
Press [TEMPO].
[TEMPO] lights, and the “TEMPO” screen appears.
2.
Press [F2 (SYNC)].
The “TEMPO SYNC” screen appears.
fig.06-Tempo4_70
3.
Use [+/-] or [VALUE] to make settings.
4.
Press [KIT] to return to the “DRUM KIT” screen.
INTERNAL:
The TD-20’s tempo setting will be used for playback/
recording. When shipped from the factory, this setting is
selected.
EXTERNAL:
The TD-20’s sequencer will operate in accordance with
tempo data (MIDI Clock) from the external device.
AUTO:
This is a convenient setting that combines features of both
the INTERNAL and EXTERNAL settings. When no
synchronization signal is being received, the TD-20’s
tempo setting will be used for playback/recording. When
a synchronization signal is being received from an
external device, the TD-20 will sync to that signal.
REMOTE:
The TD-20 will obey start/pause/stop messages from an
external device, but will playback according to its own
tempo setting.
Synchronizing to the playback of an
external sequencer
In this case, the TD-20 will be the slave and an external
sequencer will be master.
1.
Connect the TD-20’s MIDI IN connector with a
MIDI cable to the MIDI OUT connector of the
external sequencer.
2.
Set Sync Mode to “EXTERNAL.”
3.
Begin playback on the external sequencer.
Synchronized playback will begin.
Tempo Adjustment
Setting the Tempo by Hitting a Pad
(Tap Tempo)
Synchronizing with an External MIDI
Device
Parameter Value Description
Sync Mode INTERNAL, EXTERNAL,
AUTO, REMOTE
See below.
TD-20_Ref_e.book 53 ページ ２００５年５月２５日 水曜日 午前９時４９分