Filter
Top Products
47
Chapter 5. Trigger Settings [TRIGGER]
Chapter 5
[TRIGGER]
5.
Set the trigger type for hi-hat to “VH11” (p. 44).
6.
Press [TRIGGER] - [F3 (HI-HAT)].
* The “TRIGGER HI-HAT” screen appears.
7.
Set the TD-20’s parameters as described below.
8.
While reading the meter displayed on the right
side of the TD-20’s screen, adjust the offset
with the VH-11’s VH offset adjustment screw.
Adjust the offset so that the black appear in the
meter.
fig.05-TrigVH11_70
* For detailed descriptions regarding the VH-11, instructions on
connections, and other information, refer to the VH-11
Owner’s Manual.
When two pads are mounted on the same stand, hitting one
pad may trigger the sound from another pad unintentionally.
(This is called
crosstalk
.) Eliminate this by adjusting Xtalk
Cancel on the pad that is sounding inadvertently.
In some cases, you can prevent crosstalk between two
pads by increasing the distance between them.
1.
Press [TRIGGER] - [F4 (XTALK)].
2.
Use [F1]–[F3] to select the parameter.
3.
Strike the pad you wish to set.
The cursor will move to the trigger input number for the
struck pad.
You can also select by using [CURSOR] or [TRIG
SELECT].
4.
Use [+/-] or [VALUE] to adjust the setting.
5.
When you’re finished, press [EXIT] to return to
the “DRUM KIT” screen.
[F1 (XTALK)]:
XTALK CANCEL
fig.05-Xtalk1_70
[F2 (MOUNT)]:
MOUNT TYPE
Select the pad mount type here.
PAD:
Using a pad mount
CYMBAL:
Using a cymbal mount
fig.05-Xtalk2_70
[F3 (GROUP)]:
XTALK GROUP
Crosstalk Cancel affects the pads set to the same number.
fig.05-Xtalk3_70
Parameter Value
Hi-Hat Type VH11/FD
Foot Splash Sens +8
CC Max 90
CC Resolution NORMAL
Eliminate Crosstalk Between
Pads [F4 (XTALK)]
Crosstalk Example: If you hit the snare pad and
the tom 1 also sounds
Set the snare and tom 1 to the same group. Raise the
“XTALK CANCEL” for the pad being used for the tom 1.
The tom 1 pad will be less prone to receive crosstalk from
other pads. With a setting “OFF,” crosstalk prevention
will not work.
* If the value is set too high, and two pads are played
simultaneously, the one that is struck less forcefully may
not sound. Be careful and set this parameter to the
minimum value required to prevent crosstalk.
TD-20_Ref_e.book 47 ページ ２００５年５月２５日 水曜日 午前９時４９分