Filter
Top Products
41
Chapter 4. Effect Settings
Chapter 4
[EFFECTS]
REVERB
Adds reverberation to the sound, simulating an acoustic
space.
GATE REVERB
This is a special type of reverb in which the reverb is cut off
without being allowed to decay naturally.
DELAY
Adds the delay sound.
PANNING DELAY
This is a delay effect with echoes that pan left and right.
BEAT DELAY
This is a delay effect that synchronizes with a tempo in
sequencer.
* If you set Tempo, Time, and Shift to make the delay time over
1500 ms, the delay time cannot be more than 1500 ms.
Multi-Effects Parameters
Parameter Value Description
Room Type 1–5 Type of reverb
1: Lite
2: Medium
3: Deep
4: Shallow
5: Thin
PreDly 0–100.0 (ms) Time until the reverb is
heard
Time 0–127 Duration of reverbera-
tion
HiDamp 4.0k–12.5k (Hz),
THRU
Frequency above which
the reverb is reduced in
level
HiCut 160–12.5k (Hz),
THRU
Frequency above which
the high-frequency con-
tent of the reverb sound
is filtered out
Parameter
Value Description
Room Type
1–5 Type of reverb
1: Lite
2: Medium
3: Deep
4: Shallow
5: Thin
Time 0–127 Duration of reverbera-
tion
HiCut 160–12.5k (Hz),
THRU
Frequency above which
the high-frequency con-
tent of the reverb sound
is filtered out
HiDamp 4.0k–12.5k (Hz),
THRU
Frequency above which
the reverb is reduced in
level
Thre
(Threshold)
-60– +12 (dB) Volume level at which
the reverb starts to be
gated
Hold 0.05–2.00 (s) Time from when the re-
verb level falls below
the Threshold until the
gate starts to close
Rels
(Release)
0–200 (ms) Time from the start to
the completion of the
gate closing process
Parameter Value Description
Time 0–2000 (ms) Time until the delay
sound is heard
Feedback -98–98 (%) Amount of the delay
sound that is fed back
into the effect (minus:
inverts the phase)
Parameter Value Description
TimeL
0–1500 (ms) Time until the delay
sound is heard
TimeR
Level L 0–127 Volume level of the de-
lay sound
Level R
Feedback -98–98 (%) Amount of the delay
sound that is fed back
into the effect (minus:
inverts the phase)
Parameter
Value Description
Time
32th note–half
note
Time until the delay
sound is heard
Shift -half note–0–
+half note
Time of shifting the in-
terval between the 1st
and 2nd delay
Level 1 0–127 Volume level of the de-
lay sound
Level 2
Pan 1 L15–CTR–R15 Stereo position of the
delay sound
Pan 2
Feedback -98–98 (%) Amount of the delay
sound that is fed back
into the effect (minus:
inverts the phase)
Parameter Value Description
TD-20_Ref_e.book 41 ページ ２００５年５月２５日 水曜日 午前９時４９分