Filter
Top Products
76
Chapter 10. Settings for the Entire TD-20 [SETUP]
1.
Press [SETUP].
[SETUP] lights.
2.
Press [F1 (MIDI)] - [F3 (CTRL)].
The “MIDI CONTROL” screen appears.
fig.10-MidiCtrl_70
3.
Press [CURSOR (up/down)] to select the
parameter.
4.
Use [+/-] or [VALUE] to make settings.
* When a control change is set to be more than one parameter, an
asterisk (
*
) appears at the right of the unavailable parameter.
HH Note# Border
(Hi-Hat Note Number Border)
The only time you would need to change this setting is
when you are triggering an external sound module.
The note number transmitted when you strike the hi-hat will
change depending on the amount of pressure on the hi-hat
pedal. Hi-Hat Note Number Border allows you to adjust the
pedal position at which the note number switches from the
open hi-hat to the closed hi-hat.
At the factory default value (127), the closed hi-hat note
number will be transmitted only if the hi-hat pad is played
with the pedal completely depressed. If you want this note
number to be transmitted when the pedal is slightly raised, set
this to a value such as 90.
If you change the Hi-hat Note Number Border setting, the
hi-hat of a pattern that was recorded onto the internal
sequencer by playing the pads may play back in a way
that is different from the actually recorded performance.
Each drum kit/percussion set has its own program change
number.
1.
Press [SETUP].
[SETUP] lights.
2.
Press [F1 (MIDI)] - [F4 (PROG)].
The “MIDI PROGRAM CHANGE (DRUM KIT)” or
“MIDI PROGRAM CHANGE (PERC SET)” screen
appears.
fig.10-MidiPcDrum_70
fig.10-MidiPcPerc_70
3.
Press [F3 (DRM KIT)], [F4 (PRC GRP)], and
[CURSOR (up/down)] to select the drum kit or
percussion set you wish to set.
[F3 (DRM KIT)]: Drum Kit
[F4 (PRC GRP)]: Percussion Set
4.
Use [+/-] or [VALUE] to make settings.
The drum kits/percussion sets will switch when a Program
Change message is received from an external MIDI device.
When you switch TD-20’s drum kits/percussion sets, the
Program Change number set here is transmitted.
Turning the Reception/Transmission of
Program Changes On/Off
In the “MIDI PROGRAM CHANGE (DRUM KIT)” or “MIDI
PROGRAM CHANGE (PERC SET)” screen, pressing [F1]
turns the reception of program changes on or off, and pressing
[F2] turns the transmission on/off.
MIDI Messages for Detailed
Performance Expressions [F3 (CTRL)]
Parameter Value Description
Pedal CC OFF,
MODULATION(1),
BREATH(2),
FOOT(4),
EXPRESSION(11),
GENERAL1(16)–
GENERAL4(19)
Control change used
for transmitting/re-
ceiving the depth to
which the hi-hat
pedal pressed
Snare CC Control change used
for transmitting/re-
ceiving the strike po-
sition of the snare,
ride, and tom 1–4
Ride CC
Toms CC
HH Note#
Border
0–127 See below.
Switching Drum Kits via MIDI
(Program Change) [F4 (PROG)]
TD-20_Ref_e.book 76 ページ ２００５年５月２５日 水曜日 午前９時４９分