Filter
Top Products
49
Chapter 5. Trigger Settings [TRIGGER]
Chapter 5
[TRIGGER]
You can also eliminate this problem of retriggering with
the Mask Time setting. Mask Time does not detect trigger
signals if they occur within the specified amount of time
after the previous trigger signal was received. Retrigger
Cancel detects the attenuation of the trigger signal level,
and triggers the sound after internally determining which
trigger signals were actually generated when the head
was struck, while weeding out the other false trigger
signals that need not trigger a sound.
When playing a kick trigger the beater can bounce back and
hit the head a second time immediately after the intended
note—with acoustic drums sometimes the beater stays against
the head—this causes a single hit to “double trigger” (two
sounds instead of one). The Mask Time setting helps to
prevent this. Once a pad has been hit, any additional trigger
signals occurring within the specified “Mask Time” (0–64
msec) will be ignored.
fig.MaskTime.e
Mask Time:
0–64 (ms)
Adjust the “Mask Time” value while playing the pad.
When using a kick trigger, try to let the beater bounce back
and hit the head very quickly, then raise the “Mask Time”
value until there are no more sounds made by the beater
rebound.
* When set to a high value, it will be difficult to play very
quickly. Set this to as low a value as you can.
If two or more sounds are being produced when you
strike the head just once, then adjust Retrig Cancel.
When a PD-125/120/105, PD-80R, PD-9/8/7, CY series pad,
VH-12, or RT-5S (trigger) is connected, you can adjust the
relation between your playing velocity (force) on the rim/
edge and the resulting volume level.
Rim Gain:
0–3.2
Higher value allows the rim/edge to produce a loud volume
even when played softly. Lower value will keep the rim/edge
producing a low volume even when played forcefully.
When a PD-125/120/105/80R or RT-5S (trigger) is connected,
you can adjust the sensitivity of the rim response.
RimShot Adjust:
0–8.0
There are some cases that you have a rim sound unexpectedly
when you hit the head strongly. You can improve this
situation with decreasing the value of “RimShot Adjust.”
* When you set the value too small, it might be difficult to play
the rim sound.
When a PD-125/120/105/80R or RT-5S (trigger) is connected,
you can determine the “cross over point” between the cross
stick and a rim shot sounds.
XStick Thrshld:
0–127
Setting this to a higher value makes it easier to get cross stick
sounds. When set to “0,” playing a cross stick produces the
open rim shot sound.
* Increasing the value excessively may cause the cross stick to
sound as well when the open rim shot is played.
fig.MaskTime.e
Double Triggering Prevention
(Mask Time)
Rim/Edge Dynamic Response
(Rim Gain)
Time
Mask Time
Sound not produced
Rim Shots Response (Rim Shot Adjust)
Cross Stick Threshold
(XStick Thrshld)
Striking
force
Volume Levels
Rim Shot
Sound
Cross Stick
Sound
Cross Stick Threshold
(0–127)
HardSoft
High
Low
TD-20_Ref_e.book 49 ページ ２００５年５月２５日 水曜日 午前９時４９分