Filter
Top Products
65
Chapter 7. Sequencer (Recording/Editing)
Chapter 7
[REC]
This connects two patterns to create one pattern. The pattern
specified as “Dst” will be first, and the pattern specified as
“Src” will be connected to it. The new pattern will be created
in “Dst.”
fig.07-Apd1
1.
Press [PATTERN] - [F4 (EDIT)].
The “PATTERN EDIT” screen appears.
2.
Press [F2 (APPEND)].
“APPEND PATTERN” screen appears.
fig.07-Apd2_70
3.
Press [CURSOR (up)] to move the cursor to
“Src.”
4.
Use [+/-] or [VALUE] to select the pattern that
will come later.
5.
Press [CURSOR (down)] to move the cursor to
“Dst.”
6.
Use [+/-] or [VALUE] to select the pattern that
will come first.
7.
Press [F5 (APPEND)].
The confirmation screen appears.
fig.07-Apd3_70
8.
Press [F5 (EXECUTE)].
* To cancel, press [F1 (CANCEL)].
This erases the pattern. Performance data is erased, while beat,
measure length, and other settings are left intact.
fig.07-Ers1
You can erase portions of the pattern, in measure units. The
erased portions become blank measures.
fig.07-Ers2
Although the data is erased, the pattern length is
unchanged.
1.
Press [PATTERN] - [F4 (EDIT)].
The “PATTERN EDIT” screen appears.
2.
Press [F3 (ERASE)].
The “ERASE PATTERN” screen appears.
fig.07-Ers3_70
3.
When you want to erase selected measures or
part, press [F4 (MEASURE)].
The “ERASE PATTERN MEASURE” screen appears.
fig.07-Ers4_70
4.
Press [CURSOR (left/right)] to select the
parameter.
5.
Use [+/-] or [VALUE] to select the pattern, part,
and measures.
Connecting Two Patterns [F2
(APPEND)]
Dst
+
12 43
Src
12 43
Dst
12 643785
Erasing a pattern [F3 (ERASE)]
12 643785
12 643785
12 643785
12 643785
TD-20_Ref_e.book 65 ページ ２００５年５月２５日 水曜日 午前９時４９分