Filter
Top Products
63
Chapter 7. Sequencer (Recording/Editing)
Chapter 7
[REC]
(5) Set the Recording Method
1.
In the “PATTERN” screen, press [REC].
[PLAY] flashes, and [REC] lights.
The “PATTERN REC STANDBY” screen appears, and the
click sound begins to play.
fig.07-Rec5-1_70
2.
Press [CURSOR (up/down)] to select the
parameter.
3.
Use [+/-] or [VALUE] to make settings.
Quantize
Quantize is a function that corrects timing inaccuracies while
you record. Set the note value before you begin recording and
everything you play will be quantized automatically.
The value should be set to the shortest note appearing in the
phrase. When set to “OFF,” the pattern is recorded exactly as
played.
* When using Tap Playback to play back a pattern you have
created, first make sure that this is not set to “OFF,” then
quantize. If set to “OFF,” then Tap Playback cannot be
executed correctly.
Rec Mode
LOOP ALL:
The entire pattern will be repeated in loop mode and you
can continually record (like overdubbing).
LOOP 1, LOOP 2:
Recording in a one or two measure loop mode.
REPLACE:
Recording will continue until you press [STOP]. Any
previously recorded data for all Parts will be erased.
(6) Recording
1.
Press [PLAY] to begin recording.
[PLAY] stops flashing and remains lit, and the
“PATTERN RECORDING” screen appears.
fig.07-Rec6-1_70
2.
Play with pads or MIDI keyboards to record.
3.
Press [STOP] to stop recording.
[PLAY] and [REC] go off.
You can name the recorded pattern (p. 59).
The Rehearsal function temporarily suspends recording
during the recording process, allowing you to rehearse and
then quickly resume recording.
1.
Start recording (p. 61).
2.
While recording is underway, press [REC].
[REC] flashes, and the REHEARSAL screen appears.
Now, data from pads or keyboard cannot be recorded.
fig.07-Rehearsal_70
3.
Press [REC] to resume recording.
[REC] lights.
Parameter Value Description
Tempo 20–260 –
Quantize 8th note–
64th note,
OFF
See below.
Rec Mode LOOP ALL,
LOOP 1–2,
REPLACE
See below.
Hit Pad
Start
OFF, ON When “ON,” recording
starts the instant you strike
a pad in recording stand-
by mode. Press [F5 (HIT-
PAD)] to turn on/off.
This function can be
used only when Local
Control (p. 75) is set to
“ON (DRUM).”
Checking the Tones and Phrases
During Recording (Rehearsal)
TD-20_Ref_e.book 63 ページ ２００５年５月２５日 水曜日 午前９時４９分