Filter
Top Products
22
Basic Operation
This section describes how to switch (transition) video inputs and mix audio inputs from external sources.
If a fade is applied to the final output, the video is not output to a projector or other output devices. Adjust the [OUTPUT FADE] dial to its center
position. For information about fades in final output, refer to “Applying a Fade to Final Video Output” (p. 24).
Using the Touch Panel to Switch the Video
1. Display the input from the sources.
At [MONITOR], press the [INPUT] button. The input from the respective source is displayed at [1] through [4]. When the VR-3 starts
up, [1] is selected, and a red border is displayed around the [1] section.
fig.select-input-mode.eps
2. Select a transition effect.
Use the [TRANSITION] buttons to select a transition effect. When you are selecting [CUT], the switch is instantaneous, and no
transition effect is applied. If you want to apply a transition effect, select [MIX] or [WIPE].
fig.select-transition.eps
• The duration of the transition effect is set at 0.5 seconds by default.
• You can choose from eight types of wipe patterns.
• You can change the direction of the wipe, and also apply soft edges to the wipe.
You can use the menus to modify the items just described and change the settings for the transition effect. Refer to “Menu Operations” (p. 44)
and “VIDEO Menu” (p. 45).
Switching the Video
MIX
A BAB
Start
Finish
WIPE
A B
CUT
A B
No transition effect is applied.
Video sources blend together during
the switch process.
Video sources wipe from one to the other
during the switch process (default : vertical wipe).
A
B