Filter
Top Products
49
Appendices
No picture is output from the projector.
Is the [OUTPUT FADE] dial centered?
A fade is applied to output if the dial is turned either clockwise or counterclockwise. When performing output, adjust the dial to
center. The indicator above the dial lights up when the dial is at center. The indicator flashes when the dial has been turned either
clockwise or counterclockwise.
No microphone audio is output, even when the faders are raised.
Have the [GAIN] dials been turned to appropriate positions?
When input sensitivity has been lowered, no audio is output even when the faders are raised.
Is the connected microphone a condenser mic?
When you connect a condenser microphone that requires power supply, set the [PHANTOM] switch to ON.
Transition effects are not applied.
Is the length of time for transition effects (TRANSITION TIME) set at zero?
When the time is set at zero, no transition effects are applied even when [MIX] or [WIPE] is selected.
A logo cannot be input from a computer.
Is the RGB output from the computer at a resolution supported by the VR-3?
RGB signals at a resolution that the VR-3 does not support cannot be input correctly. For supported resolutions, check “Main
Specifications.”
When you connect the computer, did you connect to the [PC IN] connector, not to [THRU] connector?
The [THRU] connector is for passing output through.
Video from the computer is corrupted.
When a rapidly moving video is input from a computer, flicker or other picture corruption may occur. This is called “tearing,” and
does not indicate an equipment malfunction.
Compositing a logo is not possible.
Is the extraction color set correctly? Alternatively, was the [KEY LEVEL] dial turned in the wrong direction?
By default, black is extracted for luminance keying. If the background is a different color, then correct extraction is not possible.
Correct extraction is also impossible when the [KEY LEVEL] dial has been turned in the wrong direction.
No reverb is applied when the dial is turned.
Is [REVERB SW] at the AUDIO menu set to [OFF]?
When this is set to OFF, no reverb is applied when the dial is turned. Also, when the reverb send amount on the input channel is
too low, it can be difficult to discern the reverb.
Troubleshooting