Filter
Top Products
9
Power Supply
* Once the connections have been completed (p. 8,), turn on power to your various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to speakers and other devices.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.
* Always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear
some sound when the power is switched on, but this is normal, and does not indicate a malfunction.
Make sure the power cable is securely inserted, then press the [POWER] button located on the rear panel. The buttons and
indicators on the top panel flash, and the VR-3 starts up.
fig.power-button.eps
Press the [POWER] button on the rear panel. The buttons and indicators on the top panel go dark, and the power to the VR-3 is
switched off.
About AUTO OFF
When all of the conditions described below continue for 240 minutes or longer, the AUTO OFF feature automatically turns off
power of the VR-3.
• No operation is carried out (including remote control operation).
• No video signal is input.
• No audio signal higher than -64 dBu is input.
You can disable the AUTO OFF feature by going to the [SYSTEM] menu and setting [AUTO OFF] to [OFF]. Refer to “Menu Operations” (p. 44) and
“SYSTEM Menu” (p. 47).
The settings you were editing will be lost when the power is turned off. If you want to keep you settings, you must save your settings before
turning the power off.
Turning the Power On
Turning the Power Off