Filter
Top Products
Moving Parts 99
D24—Owner’s Manual
Moving Parts
The Part Move function is used to move part of a track. Existing material on the desti-
nation track is overwritten by the Move function. The part on the source track is left
empty.
The following points, which can be adjusted in sub-frame steps, can be selected when
specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from
1 through 99. Note that you must set these points before entering the Part Move func-
tion. See the Quick Locate Chapter on page 57 for more information about setting
these points.
1 Press the [EDIT] button.
The EDIT indicator lights up.
2 Use the JOG/DATA dial to select “PART EDIT,” and then press the [ENTER] but-
ton.
3 Use the JOG/DATA dial to select “MOVE,” and then press the [ENTER] button.
“PART MOVE—FROM TR nn” appears on the display (“nn” being the number of the
track from which the part is to be moved).
4 Use the JOG/DATA dial to select the source track.
You can select individual tracks, track pairs, or all tracks: 1–8, 1/2–7/8, or ALL. To move
part of a virtual track, assign it to a main track first, and then move.
5 Press the [ENTER] button.
“MOVE TR nn—ST MARK IN” appears on the display (“nn” being the number of the
selected track and “ST” being the start point of the part to be moved).
6 Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
7 Press the [ENTER] button.
“MOVE TR nn—ST 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
8 Use the JOG/DATA dial or keypad to adjust the start position, and then press
the [ENTER] button.
“MOVE TR nn—ED MARK IN” appears on the display (“ED” being the end point of
the part to be moved).
9 Use the JOG/DATA dial to select one of the following points: MARK IN, MARK
OUT, MARK A, MARK B, or a locate memory from 1 through 99.
10 Press the [ENTER] button.
If the duration of the specified part is less than 15 milliseconds, the minimum size, the
message “TOO SHORT” appears.
“MOVE TR nn—ED 00:00:00.00.0” appears on the display (“00:00:00.00.0” being the
position of the selected point).
11 Use the JOG/DATA dial or keypad to adjust the end position, and then press
the [ENTER] button.
“MOVE TR nn—TO TR nn” appears on the display (“TO TR nn” being the destination
track).