Filter
Top Products
Setting the SCSI ID of the Internal MO Drive 193
D24—Owner’s Manual
Appendix
Setting the SCSI ID of the Internal MO Drive
Setting the SCSI ID of the internal MO disk drive involves removing the D24’s top cover
and setting the DIP switch located on the MO drive’s circuit board.
This procedure should be carried out by a qualified engineer. If in doubt, contact your
Yamaha dealer.
1 Remove the top-cover fixing
screws (11), as shown here.
2 Remove the top cover.
3 Using a small flat-bladed screw-
driver, or something similar, set
DIP switches 1 through 3, as
listed below, to achieve the
required SCSI ID.
SCSI IDs 6 and 7 are not listed, since they are reserved for other purposes.
SCSI ID
DIP switch number
123
5
ON OFF ON
4
ON OFF OFF
3
OFF
ON ON
2 (default)
OFF
ON OFF
1
OFF OFF
ON
0
OFF OFF OFF
12345678
OFF