Filter
Top Products
72 Chapter 7—Punch In/Out Recording
D24—Owner’s Manual
Auto Punch In/Out Rehearsal
The Rehearse function allows you to practice auto punch-in/out recording without
actually recording anything to disk. With the Auto Input monitoring function turned
on, playback and input monitor switching is performed automatically at the LAST REC
IN and OUT points. See “Monitoring” on page 42 for more information.
The following illustration shows the procedure for auto punch-in/out rehearsal.
1 Set the LAST REC IN and OUT points. See “Setting the LAST REC IN & OUT
Points” on page 71 for more information.
2 Use the [RECORD READY] buttons to select tracks for recording.
The corresponding READY indicators flash.
3 Press the [AUTO PUNCH] button.
The AUTO PUNCH indicator flashes and “AUTO PUNCH—REC TAKE 1” appears on
the display.
4 Press the [REHE] and [PLAY] buttons simultaneously.
The PLAY button indicator lights up, the REHE indicator flashes, and “REC TAKE 1”
disappears from the display. The Pre-roll point is located, and then playback starts. The
Pre-roll time is set using the Pre Roll function. “Setting the Pre-roll Time” on page 76
5 Rehearsal punch in is performed automatically at the LAST REC IN point.
The REHE and READY indicators light up continuously.
6 Rehearsal punch out is performed automatically at the LAST REC OUT point.
The REHE indicator goes out and the READY indicators flash.
Playback continues up to the Post-roll point at which playback stops, the PLAY button
indicator goes out, the Pre-roll point is located, and the D24 waits.
7 Press the [AUTO PUNCH] button to leave Auto Punch In/Out.
The AUTO PUNCH indicator goes out.
LAST REC IN
point
Rehearse
Locate
PlayPlayLocate
LAST REC OUT
point
Pre-roll
point
Post-roll
point
1
2
3
4
5
6
7
8
1-1
2-1
3-1
4-1
5-1
6-1
7-1
8-1
READY 2
REHE
PLAY
AUTO
PUNCH
2
RECORD
READY