Filter
Top Products
66 Chapter 6—Quick Locate
D24—Owner’s Manual
Recalling Locate Points
Stored locate points can be recalled using the Locate Memory Recall function.
1 Press the [LOC MEM RECALL] button.
The LOC MEM RECALL indicator lights up, “RECALL MEM nn” (the flashing “nn”
being the memory number), and the value stored in the locate memory appear on the
display. If no value has been stored in the memory, “--:--:--.--.-” is displayed.
2 Use the keypad or JOG/DATA dial to select a locate memory from 1 to 99.
To enter number 37, for example, press [3] and then [7].
To cancel your selection and select another locate memory, press the [CANCEL] but-
ton, and then reenter the locate memory number.
3 Press the [ENTER] button to fix the selected memory number.
The memory number “nn” stops flashing.
Alternatively, press the [LOCATE] button to locate the selected point straightaway.
4 Press the [LOCATE] button to locate the recalled position.
The specified position is located and the position appears on the main counter, as
shown below.
5 Press the [LOC MEM RECALL] button to leave the Locate Memory Recall func-
tion.
The LOC MEM RECALL indicator goes out.
Locate points are recalled with sub-frame accuracy.
In the following example, locate memory number 5 is recalled and located.
HMSF
rec all mem01
000327000
00 00 00 00
HMSF
rec all mem01
000327000
00 03 27 00
00:00:00.00 00:01:00.00
LOC MEM
RECALL
LOCATE
5
LOC MEM
RECALL
Current
position
ENTER