PDS • User’s Guide 109
7. PDS-902 3G Enhancements
Front and Rear Panel Enhancements
cêçåí=~åÇ=oÉ~ê=m~åÉä=båÜ~åÅÉãÉåíë
This section discusses the new features of the PDS-902 3G front and rear panels.
mapJVMO=Pd=cêçåí=m~åÉä
Figure 7-1. Front panel
The front panel of the PDS-902 3G adds two buttons to support PIP functionality. In
addition, the LOGO and BLACK buttons have been combined into a single LOGO BLACK
button, and the function of the FRZ (Freeze) button depends on which output display mode
you select.
1) The LOGO BLACK button uses the system transition rate to transition to a logo or
black. If there is no stored logo, the transition is to black.
The factory default setting is to transition only after you press TAKE. However, if
Auto Take feature is ON, pressing TAKE is not necessary.
~ If Auto Take is ON:
Press to set up a transition to black or a logo. The button light blinks
during the transition, and is lit solid when the transition completes.
~ If Auto Take is OFF:
Pressing the button sets up the transition. Press TAKE to bring the
selection to Program.
2) The PIP1 and PIP2 buttons enable the display of one or two PIPs on the Preview
output, and to transition one or both to Program.
~ To display the PIP that is currently offscreen, tap the appropriate PIP
button. The button light blinks. Press TAKE to transition the PIP
onscreen.
~ To hide the PIP that is currently onscreen, tap the appropriate PIP
button. The button light blinks. Press TAKE to transition the PIP
onscreen.
~ To select the input source to pend for a PIP, press and hold a PIP button,
then select the input source.
3) FRZ (Freeze) button functionality is determined by the output display mode:
SEL
ESC
Adjust
2 7 8
36
1
5
4
SDI
Inputs
LOGO
BLACK
FRZ PIP1 PIP2
TAKE
Effects
PDS-902 3G
Main Menu
Input >>
> In Auto Acquire ON
Output >>
