PDS • User’s Guide 165
_K==oÉãçíÉ=`çåíêçä
Command Updates — Firmware Revision 3.00
`çãã~åÇ=réÇ~íÉë=Ô=cáêãï~êÉ=oÉîáëáçå=PKMM
This section describes commands that have been added, and a command that has been
removed, in Firmware Revision 3.00.
oÉîáëáçå=PKMM=`çãã~åÇë
The following commands have been added or modified for Firmware Revision 3.00:
ea`mpq^q
• Description: Query only command for the input or output HDCP status.
• Parameters:
-i (input): 5 - 6; 7 - 8
or
-o (output): 1 - DVI, 3 - Preview DVI
-m (mode):
For input query -
0 - no device is connected or HDCP protected
content is not detected.
1 - a signal has been detected and HDCP protected
content is detected.
For output query -
0 - no device is connected or HDCP authentication
has failed
1 - a device is connected and HDCP authentication
was successful
• Query Format:
HDCPSTAT -i (input) -?
or
HDCPSTAT -o (output) -?
• Query Response:
HDCPSTAT -i (input) -m (mode) --min 0 --max 1
or
HDCPSTAT -o (output) -m (mode) --min 0 --max 1
fcfii
• Description: Sets the input fill mode
• Command Format: IFILL -i (input) -m (fill mode)
IFILL -i 1 -m 1 --min 1 --max 3 -e 0
• Parameters:
-i (input): 1-6, 9 (PDS-701); 1 - 9 (PDS-901/902)
-m (fill mode): 1 - Native, 2 - Zoom, 3 - Stretch
