Filter
Top Products
71
5. Song mode
Erasing data from a song
CLEAR SONG .........................................................................
1. If the EMX-1 is playing, press the STOP/CANCEL key to stop play-
back.
2. Hold down the shift key and press step key 11 (CLEAR SONG). (Key
11 will blink.)
3. Press step key 11 once again to erase the data from the song. If you
decide to cancel, press the STOP/CANCEL key.
If you erase song data by accident
Turn the dial to re-select that song without saving it, and you will
revert to the data that was previously saved.
Changing the pattern in a specific position
1. If the EMX-1 is playing, press the STOP/CANCEL key to stop playback.
2. Use the [ ]/[ ] cursor keys to select “Position” in the display.
3. Use the dial to select the position whose pattern you want to change.
4. Press the [ ] cursor key until the display reads “Pattern.”
5.
Use the dial to select the pattern that you want to assign to that posi-
tion. If you want to listen to the selected pattern to hear whether it is
the one you want, press the Pattern mode key to enter Pattern mode,
and play it. To return to Song mode, press the STOP/CANCEL key to
stop playback and then press the Song mode key.
Maintaining the part mute settings even
when the pattern changes
This function makes the song maintain the part mute settings while playback
continues.
MUTE HOLD ................................................................Off, On
1. Press the [ ] cursor key until the parameter display reads
“MuteHold.”
2. Turn the dial to make the desired setting.
Off: The part mute settings specified within each pattern will be
applied as the position within the song changes during play-
back. However if you change the position but the pattern is
still the same, the part mute settings will be maintained.
On: The part mute status will not change even if the position
moves to a different pattern. However at the beginning of
the song the part mute status will be as specified by the pat-
tern selected for position 1.
Playing back songs in succession
NEXT SONG .................................................. Off, S.01...S.64
When a song finishes playing, this function immediately continues
playback with the next specified song.
1. Press the [ ] cursor key until the parameter display reads
“NextSong.”
2. Turn the dial to select which song will play back following the cur-
rent song. If you select Off, playback will stop when the current song
finishes playing.
The NEXT SONG setting is ignored when playing back in synchroni-
zation with MIDI Clock messages sent from an external device. The
EMX-1 will obey Song Select messages [F3, ss] (ss: song number)
sent from the external device.
(☞p.72 “Event recording”)