Filter
Top Products
99
8. Appendix
Initializing the user data
This operation will erase all patterns and song data.
When you initialize the user data, all the patterns, songs,
and samples you created will be erased. If you want keep
the data you created, save your data on SmartMedia before
you initialize.
1. While holding down the SOLO key and WRITE/
RENAME key, turn on the power.
2. The display will indicate "ALL Init," and the PLAY/
PAUSE key will blink.
3. To execute the Initialize operation, press the blink-
ing PLAY/PAUSE key. To cancel without initializ-
ing, press the STOP/CANCEL key.
It will take about 30 seconds for initialization to be
completed.
When loading is completed, the ESX-1 will be re-
stored to its initial state, and after several seconds
the display will indicate pattern number "A.01" and
enter Pattern mode.
Never turn off the power while the ESX-1 is being
initialized.
Specifications
Number of parts: 16 parts
2 keyboard parts, 9 drum parts, 1 drum accent
part, 1 stretch part, 1 slice part, 1 audio in part,
1 accent part
Sample capacity: 384 (256 monaural, 128 stereo) or a maximum
of 285 seconds (monaural)
Sampling frequency:
44.1 kHz
Memory capacity: 256 patterns, 64 songs
Effects: Three processors x 16 types
Sequences: Maximum of 128 steps per part.
Motion sequences: Total of 24 freely assignable sequences totaling
Song: Maximum of 256 patterns per song.
Maximum 20,000 events for event recording.
Connectors**:
PHONES
Phone jack: stereo
Maximum output level: 16 mW/33-ohms or
more / TUBE GAIN = min
Output impedance: 33 ohms
OUTPUT (L/MONO, R)
Phone jacks: mono x 2
Maximum output level: 0 dBu or more / TUBE
GAIN = min
Output impedance: 220-ohm (110-ohm at
MONO)
Load impedance: 10 k-ohms or more
INDV.OUT (3, 4)
Phone jacks: mono x 2
Maximum output level: +7 dBu or more
Output impedance: 220-ohm
Load impedance: 10 k-ohms or more
INPUT (AUDIO IN)
Phone jack: stereo (unbalanced)
Input impedance: 10 k-ohms (at LINE) /
910-ohm (at MIC)
Maximum input level
(at LINE): -20dBu/ AUDIO IN LEVEL = max
(at MIC): -52 dBu / AUDIO IN LEVEL = max
Source impedance: 600 ohms
MIDI (IN, OUT, THRU)
5-pin DIN
SmartMedia
TM
: 4–128 MB, 3V (3.3V)
Vacuum tube: 12AX7/ECC83 x 2
Power supply: AC9V (included AC/AC power supply)
Power consumption
: 23 W
Dimensions: 358 (W) x 256 (D) x 62 (H) mm (including the
rubber feet)
Weight: 3.1 kg
** Analog specifications such as output levels are measured
at the point where the vacuum tubes have stabilized af-
ter power-on. These values may change due to variations
in the environmental temperature.