Filter
Top Products
49
Using the Registration Buttons
The AT-20S allows you to store sound settings and panel settings such as 4 in the Regis-
tration buttons. There are a total of 4 Registration buttons, and one set of panel settings
can be stored in each, allowing you to register a total of 4 different panel settings. Each
set of panel settings that has been stored in a Registration button is called a “Registra-
tion.”
This provides a convenient way to change large numbers of panel settings during a per-
formance, or to recall a complex panel setting.
fig.07-01
Settings that have been stored to Registration [1]–[4] buttons are remembered even if the power
is turned off. If you wish to restore the settings stored in the Registration buttons to their
factory settings, use the “Factory Reset” operation (p. 18).
Storing Registrations
1.
Make all the panel settings that you wish to store.
2.
While holding down the [Write] button, press one of the Registra-
tion [1] – [4] buttons.
The panel settings will be stored in the selected Registration button.
With the settings of Registration [1] – [4] buttons considered as one set, a single floppy disk can
store up to 99 sets of data (p. 54).
For details on the settings that are stored in a Registration, refer to “Settings That Are Stored in
the Registration Buttons” (p. 111).
Write
Manual
1
3
4
2
Registration
AT-20S.e.book 49 ページ ２００３年１１月１０日 月曜日 午後２時３７分