Filter
Top Products
73
Record and Playback Your Performance
If you load a song other than Atelier performance songs (SMF music files, etc.), the Rhythm
(drum) Part will automatically be loaded into the Rhythm track, and the other Parts loaded into
the Accomp and Bass tracks.
If loading is canceled because the memory limit has been reached, the following message will be
displayed:
fig.08-05
■
Layering a New Recording onto SMF Music Files
You can load a SMF music file into the AT-20S and play it back while you record your
own playing as an additional layer.
1.
Insert a floppy disk containing commercially available SMF music
files into the floppy disk drive.
2.
Press the Select [-] [+] buttons to select the music file that you wish
to load into the AT-20S.
3.
Press the [Load] button.
The selected music file will be loaded.
When SMF music files is loaded into the AT-20S, it will be stored in the following tracks;
Rhythm
The Rhythm performance (channel 10)
Bass
The Bass performance (channel 2)
Accomp
Performance data other than the Rhythm and Bass (except channels 2 and 10)
4.
Make the panel settings that you wish to record.
5.
Press the [Bwd] button and [Fwd] button to move to the measure at
which you wish to begin recording.
6.
Press the [Rec] button to enter record-ready mode.
The [Rec] button indicator will light, and the [Play] button indicator will blink.
7.
Press the [Play] button to begin recording.
As you record, the music file that was loaded into the AT-20S will play back.
8.
Press the [Stop] button to stop recording.
The performance data you recorded can be saved on a floppy disk (p. 70).
Commercially sold music files can also be loaded into the AT-20S, but for reasons of copyright
protection, cannot be saved in SMF format.
NOTE
NOTE
AT-20S.e.book 73 ページ ２００３年１１月１０日 月曜日 午後２時３７分