Filter
Top Products
54
Using the Registration Buttons
Saving Registration Sets to a Floppy Disk
With the settings of Registration [1]–[4] buttons considered as one set, a single floppy
disk can store up to 99 sets of data. We recommend that complex panel settings or Reg-
istrations you wish to keep be saved on disk. If AT-20S Registrations that you create are
saved on a floppy disk, they can then be recalled later or recalled for use on another AT-
20S.
1.
Make sure that the disk drive contains a disk that was formatted by
the AT-20S.
2.
Press the [Registration] button (indicator lights).
3.
Press the Select [-] and [+] buttons to select the number that you
wish to save to.
Numbers which have not been used in the Saving operation will be displayed as “- - -”.
fig.07-10
To cancel the operation, press the [Registration] button.
4.
Press the [Save] button.
5.
Press the [Bwd] or [Fwd] button to select the format in which the
data will be saved.
6.
Press the [Save] button to execute the save operation.
When the Registration set is saved to the floppy disk, the indication of “- - -” will change
to “USE.”
fig.07-11
When saving is completed, the basic screen reappears.
If you have assigned a name, the Registration set will be saved to floppy disk with that
name.
●
If the following screen appears
If you press the [Save] button for a Registration number with the word “USE” indicated,
the following message appears.
fig.07-12
❍
If you wish to update the contents of the Registration deta
1.
Press the [Rec] button.
The Registration will be rewritten.
AT-20S.e.book 54 ページ ２００３年１１月１０日 月曜日 午後２時３７分