Filter
Top Products
86
Edit Menu (Editing Song Files)
Copy Measures (Copy)
This function lets you copy a portion of recorded song to a
different measure (bar) location in the same track.
* If a recording already exists at the copy destination, it will be
erased.
Example:
If you wish to copy measures (bars) 5–7 to measure
(bar) 8
fig.10-15
1.
Press the [Function] button.
2.
Press the Select [-] [+] buttons to select “Edit
Menu.”
3.
Press the [Rec] button.
4.
Press the Select [-] [+] buttons to select “Copy.”
fig.10-16
To cancel the operation, press the [Reset] button.
5.
Press the [Rec] button.
6.
Press the [Bwd]/[Fwd] buttons to select the
track whose recording you wish to copy.
fig.10-17
Settings:
ALL
,
RHYTHM, ACCOMP, BASS, LOW-
ER, UPPER, SOLO, CONTROL
If you select “ALL”, the recording in all the tracks will be
copied.
7.
Press the [Rec] button.
8.
Press the [Bwd] / [Fwd] buttons to specify
“from” (copy start measure).
fig.10-18
9.
Press the [Rec] button.
10.
Press the [Bwd] / [Fwd] buttons to specify “for”
(number of measures from the copy start mea-
sure).
fig.10-19
To specify until the last measure (bar), set “for: ALL”.
11.
Press the [Rec] button.
12.
Press the [Bwd] / [Fwd] buttons to specify “to”
(copy destination measure).
fig.10-20
If you select “END,” the data will be copied following the
end of the last measure.
13.
Press the [Rec] button.
14.
Press the [Bwd] / [Fwd] buttons to specify
“time” (number of times to copy the data).
fig.10-21
15.
Press the [Rec] button.
The following screen appears.
fig.10-22
To cancel the operation, press the [Reset] button.
16.
To execute the Copy function, press the [Rec]
button once again.
When copying is complete, the basic screen reappears.
1 2 3 4 5 6 7
1 2 3 4 5 6 7 8 9 10
AT-20S.e.book 86 ページ ２００３年１１月１０日 月曜日 午後２時３７分