Filter
Top Products
62
Record and Playback Your Performance
You can also choose to cancel the metronome count-in before recording starts (p. 79).
If you press the [Rec] button when a song has been selected from the floppy disk, the selected
song will be completely loaded into the AT-20S and the Composer will enter into the recording
standby mode.
If you wish to record a new song, press the Select [-] and [+] buttons to first select “NEW
SONG” before pressing the [Rec] button. Alternatively, eject the disk from the floppy disk drive
before pressing the [Rec] button.
fig.08-03
●
If the following screen appears
fig.08-04
When the instrument’s memory is nearing capacity.
fig.08-05
When recording was automatically canceled because the memory limit was reached.
Recording Each Part Separately
As you listen to the recorded performance, you can record each Part in sequence.
In this method, each part is recorded one after another: first the Rhythm part, then the
bass part, etc. If there are any previously recorded performances, you can listen to them
as you record additional parts.
1.
Select the panel settings needed for recording the performance.
2.
Press the [Bwd] / [Fwd] buttons to select the desired measure (bar)
when you start recording.
If you wish to start recording from the beginning of the song, press the [Reset] button.
3.
Press the [Rec] button to enter the recording standby mode.
The [Rec] button indicator will light, and the [Play] button and the track buttons of un-
recorded tracks will blink.
The button indicators of tracks that are already recorded will light.
4.
Press the [Play] button to start recording.
When you press the [Play] button, the metronome will play two measures (bars) of
count-in before recording begins. As you listen to the performance song previously re-
corded, record the Part into a new Track.
5.
Press the [Stop] button when your recording is completed.
The track button indicators for which performance data has been recorded will be lit.
NOTE
AT-20S.e.book 62 ページ ２００３年１１月１０日 月曜日 午後２時３７分