Filter
Top Products
3. Use [INC/DEC] or the VALUE dial to make the settings.
4. Press [F4 (CLEAR)]
A confirmation display will appear.
5. Press [F4 (EXEC)]and the contents of the selected mea-
sures will be cleared. (Press [F1 (CANCEL)] to return to
the previous page without executing the operation.)
■
Connecting two patterns
This operation connects two patterns to create one pattern.
The pattern specified as “Dst” will be first, and the pattern
specified as “Src” will be connected to it. The new pattern
will be created in “Dst.”
fig.07-16
Procedure
1. Press [PATTERN]-[F3 (EDIT)]-[F4 (APPEND)].
The “APPEND PATTERN” page will appear.
2. Use [CURSOR] to move the cursor to “Src.”
3. Use [INC/DEC] or the VALUE dial to select the pattern
that will come later.
4. Use [CURSOR] to move the cursor to “Dst.”
5. Use [INC/DEC] or the VALUE dial to select the pattern
that will come first.
6. Press [F4 (APPEND)]
A confirmation display will appear.
7. Press [F4 (EXEC)] and the patterns will be connected as
specified above. (Press [F1 (CANCEL)] to return to the
previous page without executing the operation.)
* If the result of connecting the patterns would exceed 99 mea-
sures, the display will indicate “99 MEASURE MAXIMUM,”
and the APPEND operation will not be executed.
Settings for part instruments
* Drum part settings cannot be made here. These settings are
made in the Control Room of the drum kit. (refer to p. 90–96).
fig.07-17
■ Adjusting the master tuning
Here you can adjust the overall tuning for Part 1, Part 2, and
the Bass part.
Procedure
1. Press [PART]-[F3 (M TUNE)].
The “MASTER TUNE” page will appear.
2. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Master Tune: 415.3–466.2, 0.1 Hz steps
* Pressing [F4 (440 HZ)] will set this to standard pitch (440.0 Hz).
■ Instrument selection and set-
tings for each part
Here you can select the instrument that will be used by each
part, and make settings for Ambience, Key Shift (pitch
adjustment in semitone steps) and Bend Range.
Procedure
1. Press [PART]-[F1 (INST)].
The “PART INST” page will appear.
2. Press [F1]–[F3] to select the part that you wish to set. The
[F1]–[F3] buttons select Part 1, Part 2, and the Bass part
respectively.
3. Use [CURSOR] to move the cursor to the parameter that
you wish to set.
4. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Inst: 1–54
Select the instrument that you wish to use.
Ambience: 0–127
Adjust the amount of ambience.
Keyshift: -24–0–+24
Specify a pitch change in semitone steps.
Bend Range: 0–+24
Specify the maximum pitch change (in semitone steps) that
will occur when pitch bend messages are received.
1234
1234
1234
5678
Dst
Dst
Src
+
APPEND
Chapter 6. Sequencer
106