Filter
Top Products
■
Changing the kit number that is
selected by a program change
You can freely select the correspondence between program
changes and drum kits, so that (for example) drum kit 10
could be selected when program change number 5 is
received.
* This would only be used in special cases when using a lot of
MIDI information from a sequencer, and using the same pro-
gram change MIDI channel to change patches in other modules,
effect units etc.
Procedure
1. Press [SETUP]-[F2 (MIDI)]-[F3 (PROG)].
The “MIDI Program Change” page will appear.
2. Use [CURSOR] to move the cursor next to the kit name
for which you wish to select a program change number.
3. Use [INC/DEC] or the VALUE dial to select the program
change number.
MIDI messages for
detailed performance
expressions
■ Messages for hi-hat control
The TD-10’s hi-hat controller also transmits the depth to
which the pedal is pressed, using control change messages.
By default (factory preset), control change 4 is used.
Reception/transmission to/from an external MIDI
sequencer will use this number.
* If the MIDI device that you are using already uses control
change number 4 for another function then you can set the hi-
hat to use a different control change number.
Procedure
1. Press [SETUP]-[F2 (MIDI)]-[F2 (CTRL)].
The “MIDI Control Change” page will appear.
2. Use [CURSOR] to move the cursor to “Pedal CC.”
3. Use [INC/DEC] or the VALUE dial to specify the control
change number.
Parameters
Pedal CC:OFF, Modulation (1), Foot Ctrl (4), General1 (16),
General2 (17)
OFF:Hi-hat data control will not be received or transmitted
via MIDI IN or MIDI OUT.
Modulation (1), Foot Ctrl (4), General1 (16), General2 (17):
The specified control change will be used for hi-hat
control. This setting will be used both for reception at
MIDI IN and for transmission from MIDI OUT.
Chapter 10. Functions using MIDI
128