Filter
Top Products
Making settings for brush
performance
For each kit you can specify whether sticks or brushes will
be used. When the trigger setting is set to “brush,” pad sen-
sitivity will be higher. Each kit has settings for sticks and for
brushes, and the brush settings can be selected as follows.
fig.03-02
Procedure
1. Press [KIT]-[F2 (FUNC)]-[F3 (SELECT)].
The “SELECT” page will appear.
2. Use [INC/DEC] or the VALUE dial to select “Brushes.”
The settings for brush performance will be selected.
* Preset drum kits for brushes are already set for brush perfor-
mance. The setting discussed here is necessary when you wish to
modify a kit that was created for stick performance in order to
play with brushes. If you wish to create a new brush kit, it’s sim-
pler to copy an existing one and then edit it as you wish.
* The setting you make here can also be viewed in the drum kit
name page (“DRUM KIT”).
* When performing brush swish/sweeping, the following condi-
tions must also be met in addition to the above setting.
Trigger jack 2 must be used. (for the snare drum)
PD-120 or PD-100 pads must be used.
Make sure that you are using instrument number 113 “Brush1
S,” number 114 “Brush2 S” or 115 “BrushTmbS.”
Effect switches for the
entire kit
Ambience, compressors, equalizers, and digital effects can
be turned on/off for the entire kit. This gives you a great
way to “compare” your sounds with or without those func-
tions.
Procedure
1. Press [KIT]-[F3 (FX SW)].
The “EFFECTS SWITCH” page will appear.
2. Each time you press a function button [F1]–[F4], the cor-
responding effect will be switched on/off.
Function buttons
[F1 (AMBNCE)]: Ambience on/off switch
[F2 (COMP)]: Compressor on/off switch
[F3 (EQ)]: Equalizers on/off switch
[F4 (EFFECT)]: Effect on/off switch
* The settings made here can also be seen in the drum kit name
page (“DRUM KIT”).
fig.03-02ae
On Off
Chapter 2. Settings for the entire drum kit
79
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10