Filter
Top Products
■ Using triggers on an acoustic drum to play the TD-10
Set the trigger type to the drum trigger setting, and if notes are not sounded accurately, you’ll need
to make changes in the “advanced” mode of this section. For details, refer to “Detailed settings for
the trigger parameters (ADVNCD)” (p. 111) in the “Advanced Use.”
First refer to p. 142 and attach the drum trigger. When you have done so, make the following set-
tings for each trigger.
fig.00-023
1
Press [SETUP], then press [F1 (TRIG)], and then press [F1 (BANK)].
The following screen will appear:
fig.00-017
This screen shows a list of the trigger types that are specified for each TRIGGER INPUT jack.
2
Use [CURSOR] to move the cursor to a location other than “BANK.”
3
Strike the drum (or press the kick pedal) for which you wish to make settings.
The cursor will move to the trigger number of the drum that you struck.
4
Use [INC/DEC] or the VALUE dial to specify the trigger type. Make the following settings for each
trigger.
“KIK”: Kick drum “TOM”: Tom
“SNR”: Snare drum “FLR”: Floor tom
Once you have completed your settings, press [EXIT] enough times to get back to the “DRUM KIT”
page.
1 2
4
Before you begin playing
33
Quick Start