Filter
Top Products
Parameters for Flying 3D-Delay 1, 2
Delay Time: 10–1200 (ms)
Adjust the time from the original sound until the delay is
heard.
Feedback Level: 0–127
Adjust the number of times that the delay repeateds.
Rotation: -150–0– +150 (R.P.M) (steps of 3)
Specify the number of rotations per minute. Positive (+) set-
tings rotate toward the right, negative (-) settings rotate
toward the left.
High EQ Gain: 0– +10
This is an equalizer that is applied only to the delay sound.
Settings for an entire group
Broad Settings can be made for the entire drum kit, backing
parts, or percussion group.
* The percussion group is a sound map that can be accessed when
the TD-10 is being used as a MIDI sound module. For details
refer to “Using the percussion group” (p. 126). Of course, indi-
vidual percussion sounds CAN be assigned to the pads.
■ Adjusting effect send level for
an entire group
You can adjust the overall amount of effect send level for the
drum kit, percussion group (p. 126), and backing parts.
Procedure
1. Press [CONTROL ROOM]-[F4 (EFFECT)]-[F2 (SNDRTN)].
The “EFFECT GROUP” page will appear.
2. Use [CURSOR] to move the cursor to the group (“Drums,”
“Perc,” or “Part”) for which you wish to make settings.
3. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Group FX Send: 0–127
Drums: The amount of effect send level for the entire drum
kit.
Perc: The amount of effect send level for the entire per-
cussion group.
Part: The amount of effect send level for the sequencer
parts (part 1, part 2, bass part).
■ Adjusting the volume by group
You can adjust the overall volume of the drum kit and per-
cussion group.
Procedure
1. Press [CONTROL ROOM]-[F1 (MIXER)]-[F4 (GRPVOL)].
The “GROUP VOLUME” page will appear.
2. Use [CURSOR] to move the cursor to the group for which
you wish to make settings (“DRUMS” or “PERC” ).
3. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Group Volume: 0–127
DRUMS:Adjusts the volume of the entire drum kit.
PERC: Adjusts the volume of the entire percussion group.
Chapter 5. Control room settings
96