Filter
Top Products
* If you do not want to trigger instrument sounds assigned to the pads, press [CONTROL ROOM]-[F1
(MIXER)]-[F1 (VOLUME)], and set the volumes of AUX 1 and AUX 2 to “0.”
* If the “Mode” setting is “KIT SELECT” or “PATTERN SEL,” striking the rim of the pad will have the
same function as pressing [DEC].
* If you wish to use Drum Kit Chain (p. 70) to select kits, set the above “MODE” parameter to “KIT
SELECT,” and press [CHAIN] to make the button indicator light. (Create your Drum Kit Chain settings
first.)
Using foot switches to perform button opera-
tions (Foot Switch)
Two foot switches (BOSS FS-5U, optional) and a special cable (PCS-31) can be used to operate the
TD-10. Set “Mode” to specify the function of the two pedals.
fig.10-03
Foot switch SW1 SW2
FS-5U x 2 (PCS-31) o (red) o (white)
DP-2 - o
o: Function -: Not function
Procedure
1. Connect the foot switch to the FOOT SWITCH jack.
2. Press [SETUP]-[F3 (CTRL)]-[F1 (FOOTSW)].
The “FOOT SWITCH” page will appear.
3. Use [INC/DEC] or the VALUE dial to select the combination of functions that the foot switch will
perform (refer to the following table).
4. Press [EXIT] to exit this page.
5. Press the foot switches, and they will function as switches.
Parameters
Mode (function name) SW1 SW2
KIT SELECT Select the previous kit Select the next kit
PATTERN SEL Select the previous pattern Select the next pattern
PATTERN PLAY Select the next pattern Playback/stop the pattern
* To use foot switches to select kits using a Drum Kit Chain (p. 70), set the above “MODE” parameter to
“KIT SELECT,” and press [CHAIN] to make the button indicator light. (Create your Drum Kit Chain set-
tings first.)
Chapter 9. Operations using pads and pedals
120