Filter
Top Products
Rear Panel
23
24
2529
30
3132
33
34
26
2728
Front and rear panel
16
MEMORY CARD Slot
An M-512E memory card (optional) can be inserted into this
slot. Each memory card can store all settings of the TD-10,
such as drum kits and sequencer performance data, etc (p.
114).
* The M-512E is the only memory card that can be used by
the TD-10.
TRIGGER INPUT Jacks
Accept the pads or kick trigger units you want to connect to
the TD-10. To connect a dual trigger type pad (PD-7, PD-9,
PD-120), use a stereo cable (p. 24).
FOOT SWITCH Jack
Accepts connection of an optional foot switch (FS-5U). A
foot switch can be used to select kits and start/stop the
sequencer, etc. Use a special PCS-31 cable (optional) (p. 72,
120).
HH CTRL Jack
Accepts connection of a hi-hat control pedal (FD-7) (p. 36).
OUTPUT (MASTER) Jacks
These jacks output the instrumental sounds of the TD-10,
and are for connection to external audio devices or amps. If
you are listening in mono, connect to only the MASTER L
(MONO) jack (p. 23).
OUTPUT (DIRECT 1, 2, 3) Jacks
The direct outs allow you to have more “separation,” over
the total kit, and can be used for external effects etc.
Ambience may also be sent from these outputs, but NOT the
digital effects. Output assignments DIRECT 1, 2 or 3 jacks
are found in the Control Room (p. 91).
PHONES Jack
A pair of stereo headphones can be connected to this jack.
Even if headphones are connected, sound will still be output
from the OUTPUT jacks (p. 23).
MIX IN Jack
This jack is used to connect a CD or cassette player, or as a
custom monitoring input for live/recording performances.
The sound that is input to this jack will be output from the
MASTER out jacks and/or the PHONES jack (p. 108).
MIDI IN Connector
Use this connector when you wish to use an external MIDI
sequencer to play the sounds of the TD-10, or when loading
TD-10 settings (bulk data) that were saved on an external
device (p. 121).
MIDI OUT/THRU Connector
Use this connector when you wish to use play sounds in an
external MIDI sound module/sampler from the pads, or
when you wish to transmit TD-10 settings (bulk data) to
another MIDI device (p. 121).
POWER Switch
This switch turns the power on/off (p. 26).
AC Inlet
Connect the included AC power cable to this inlet (p. 23).
23
24
25
26
27
28
29
30
31
32
33
34