Filter
Top Products
Tap: This function is a great performance tool! For
example if you specify “Tap” for a pattern
which contains a melody line and assign this
pattern to a pad, you can play the notes of the
melody in order each time you strike the pad.
You can set the “Reset Time” so that the pattern
will automatically return to the beginning if that
time interval elapses without that pad being hit
again. For example, you can play a bass line
with your kick drum and the two sounds will be
perfectly “tight.”
* Reset Time (Off, 0.1–4.0 seconds)
This is the time interval that resets the pattern being used. If it
is set to “Off,” this function will be disabled.
Click settings
■
Click on/off and volume settings
When you press [CLICK], the click will be turned on/off. To
adjust the volume, move the [GROUP FADERS] slider
[CLICK].
■ Setting the tempo
While pattern playback is halted, you can use the click as a
metronome. But if a different pattern is selected, the tempo
will change to the tempo specified for that pattern.
Procedure
1. Press [TEMPO].
The “TEMPO” page will appear.
2. Use [INC/DEC] or the VALUE dial to set the tempo.
Parameters
TEMPO: 20–260
■ Setting the time signature and
click interval
Procedure
1. Press [CLICK]-[F1 (INTRVL)].
The “CLICK” page will appear.
2. Use [CURSOR] to move the cursor to the parameter that
you wish to set.
3. Use [INC/DEC] or the VALUE dial to make the setting.
* It is not possible to change the time signature of the click while a
pattern is playing back. The click corresponds to the time signa-
ture of the pattern.
Parameters
Time Signature: Numerator = 0–13 (number of beats per
measure), Denominator = 2, 4, 8, 16 (basic
note value)
Interval: 1/2 (half note), 3/8 (dotted quarter note), 1/4 (quar-
ter note), 1/8 (eighth note), 1/12 (12th note), 1/16
(16th note)
Chapter 6. Sequencer
99
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10