Filter
Top Products
52 TASCAM DP-03
CUT (remove part)
This function cuts (deletes) the audio data between the
IN and OUT points on the selected track, and shifts the
remaining recording after the OUT point forward to the IN
point. Therefore, the track becomes shorter.
The following parameters are used in this operation.
CUT TRK (
•
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
,
ALL
)
IN/OUT
•
SILENCE (part erase)
This function cuts (deletes) the audio data between the
IN and OUT points on the selected track, leaving silence
between the IN and OUT points, as though there had
been no recording.
This operation does not change the length of the track.
The following parameters are used in this operation.
SILENCE TRK (
•
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
)
IN/OUT
•
TIP
Using this function, you can delete short noises, for
example.
CLONE track (track duplication)
Use this function to duplicate a single track, a track pair or
the stereo master track on a different track or track pair.
Each track is copied entirely, so the IN/OUT/TO points
have no effect.
The following parameters are used in this operation.
SOURCE TRK (
•
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
,
MST
)
DESTINATION TRK
•
NOTE
If you choose the same track for both the SOURCE TRK and
the DESTINATION TRK and press the F2 (
EXEC
) button,
the
Same
Track
message appears and the operation is
not executed.
CLEAN out (track erase)
Use this function to completely erase the selected track.
This erases the entire track, so the IN, OUT and TO points
have no effect.
The following parameter is used in this operation.
CLEAN OUT TRK (
•
1
to
8
,
1
/
2
,
3
/
4
,
5
/
6
,
7
/
8
,
1
-
8
)
8 – Editing Tracks