Filter
Top Products
<PAGE 3/5>
DIGITAL EFFECT:
Select DIGITAL EFF. Use the buttons below the display to
set the DIGITAL EFFECT to ON or OFF for the corresponding
part.
CHORUS:
Select CHORUS. Use the buttons below the display to
set the CHORUS to ON or OFF for each part.
CHORUS DEPTH:
Select CHORUS DEPTH. Use the buttons below the dis-
play to set the depth of the CHORUS for the corresponding
part (0 to 127).
<PAGE 4/5>
EQUALIZER HIGH:
Sound quality correction in the high range. Select EQUAL-
IZER HI FC; use the buttons below the display to set the
standard frequency. Select EQUALIZER HI GAIN; use the
buttons below the display to set the ratio of change.
EQUALIZER LOW:
Sound quality correction in the low range. Select EQUAL-
IZER LOW FC; use the buttons below the display to set
the standard frequency. Select EQUALIZER LOW GAIN;
use the buttons below the display to set the ratio of
change.
<PAGE 5/5>
KEY SHIFT:
Select KEY SHIFT. Use the buttons below the display to
adjust the shift width of the output pitch of each part (in
semitone increments; –24 to +24).
MIDI CHANNEL:
Select MIDI CHANNEL. Use the balance buttons below
the display to set the MIDI channel for each part (CH1–
CH16).
• Information about MIDI channels can be found on page
128.
LOCAL CONTROL:
Select LOCAL CONTROL. Use the balance buttons below
the display to turn LOCAL CONTROL ON or OFF for each
part.
• Even at the same numerical value, the PAN and effects
may differ depending on the sound.
• For some parts, such as the automatic accompaniment
parts, the items that can be adjusted are limited.
EDIT MIXER
If you press the EDIT MIXER button on the PAGE 5/5 display,
the display changes the setting display to modify the sounds.
<PAGE 1>
VIBRATO RATE:
Select VIBRATO RATE. Use the buttons below the display
to adjust the vibrato speed for each part (0 to 127).
VIBRATO DEPTH:
Select VIBRATO DEPTH. Use the buttons below the dis-
play to adjust the vibrato depth for each part (0 to 127).
VIBRATO DELAY:
Select VIBRATO DELAY. Use the buttons below the dis-
play to specify the time interval from when the keys are
played until the vibrato starts for each part(0 to 127).
FILTER RESONANCE:
Select FILTER RESONANCE. Use the buttons below the
display to set the amount of resonance applied to each
part (0 to 127).
<PAGE 2>
BRIGHTNESS:
Select BRIGHTNESS. Use the buttons below the display
to set the amount of brightness applied to each part (0
to 127).
ATTACK TIME:
Select ATTACK TIME. Use the buttons below the display
to set the sound attack time for each part (0 to 127).
DECAY TIME:
Select DECAY TIME. Use the buttons below the display
to set the sound decay time for each part (0 to 127).
RELEASE TIME: Select RELEASE TIME. Use the buttons
below the display to set the release time for each part (0
to 127).
Sound
Part VII Sound
106
QQTG0665