Filter
Top Products
Slide Show
This instrument can show various images which change automatically corresponding to the music progression just like the DEMO
performance. Using the Slide Show function, you can create a multi-media show of images synchronizing with the sound.
Schematic
Set the images
To set the images, proceed as follows.
1. Record a song in the SEQUENCER. (See
pages 65 to 67.)
2. Specify the points (PIC) at which the image
must be changed on the STEP RECORD
(CONTROL) display. (See page 73.)
3. Replay the song.
• The selected image is displayed in whole screen at the
specified point (PIC). The image continues to be shown
until the next PIC point comes.
• Images will be displayed on either the normal display or
the SEQUENCER PLAY display.
• PR804: You can output the displayed images to a external
monitor such as a TV set. (See page 136.)
Load your original images
Besides a variety of preset images of the instrument, you
can use your original images on your PC, etc.
1. Save the image data to a disk.
• The instrument can read .BMP and .JPG formats (not
compatible with all data with those extensions).
2. Insert the disk into the DISK DRIVE. (See page
96.)
3. Load the data using the STEP RECORD dis-
play.
About the measure count
The measure count on the display corresponds to the
time signature of the selected rhythm. However, if rhythm
data is stored in the RHYTHM part and that part is played
back, the measure count on the display corresponds to
the stored rhythm data. (Refer to page 75.)
• If you wish to use a time signature not available in the
preset rhythms, use the COMPOSER to create a new
time signature. (Refer to page 86.)
PICTURE 1
PIC #1
PICTURE 3
PIC #3
PICTURE 5
Ending
PIC #5
PICTURE 6
PIC #6
PICTURE 4
PIC #4
PICTURE 2
PIC #2
Intro Theme A Theme B
MEMO
• This instrument is compatible with images sized 640
x 240 pixels. Even though an image sized up to 640
x 480 pixels can be read, the data will be cut out to
640 x 240 pixels when loading.
• Depending on the size, it may not be possible to load
the image.
• After the PICTURE LOAD display appears, no sound
is produced on the instrument.
• PR604: The display consists of a monochrome, 4-
gradation screen. It is recommend that you remake
the images beforehand to adapt for the screen capacity
using a graphic application, etc, in your computer.
Sequencer
Part IV Sequencer
63
QQTG0665