Filter
Top Products
Master Tuning
This setting is used to fine-tune the pitch of the entire instrument. This is convenient when this instrument is played with other
instruments or with a recorded performance.
1. On the SOUND MENU display, select
MASTER TUNING.
• The display changes to the following.
2. Use the ∧ and ∨ buttons to adjust the pitch.
• Pressing the ∧ and ∨ buttons at the same time will reset
the tuning to the standard 440.0 Hz.
Key Scaling
For each part you can change the tuning of each key within a one-octave range. In addition to equal temperament tuning, you
can perform in other types of scales, for example Arabic tuning.
1. On the SOUND MENU display, select KEY
SCALING.
• The display looks similar to the following.
2. Press the OCTAVE TUNING TEMPLATE but-
ton.
• The display looks similar to the following.
3. Use the PART ∧ and ∨ buttons to select the
part to set.
• If ALL is selected, all the parts are set at once.
4. Use the TYPE ∧ and ∨ buttons to select the
type of tuning.
• Select from FLAT, WERCKMEISTER, KIRNBERGER,
ARABIC 1 to 5, SLENDRO, and PELOG.
5. Use the SHIFT ∧ and ∨ buttons to select the
key to perform in.
6. Repeat steps 3 to 6 for each part, as neces-
sary.
7. Press the SET button.
• The OCTAVE TUNING for the specified type and key is
automatically set.
Settings for each key.
On the KEY SCALING display, you can adjust the tuning for
each key.
Use the buttons below the display to adjust the tuning for
each key.
• The pitch can be raised or lowered by a maximum of one
half-tone.
• You can use the PART SELECT ∧ and ∨ buttons to
switch the part.
• Use the ALL PARTS INITIAL button to return all parts to
the flat tuning.
ORIGINAL tuning
Each instrument of each sound has its own original tuning
data. This setting affects the tuning curve that spans the en-
tire keyboard. So, for example, the acoustic piano-type
sounds duplicate those of a real piano, in that the high notes
are tuned slightly higher and the low notes slightly lower.
You can specify for each part whether this original tuning is
enabled or not.
1. Use the PART SELECT ∧ and ∨ buttons to
select a part.
2. Use the ORIGINAL TUNING ON/OFF button
to select ON or OFF.
Sound
Part VII Sound
107
QQTG0665