Filter
Top Products
51
Quick Guide
Using the Multi Mode
The following parameters are used to edit the System
Effect.
First select the Reverb/Chorus type, then set the return
level and panning.
n For information on the Reverb/Chorus types, refer to the
separate Data List.
• ReverbType (Reverb Type)
ReverbRtn (Reverb Return)
ReverbPan (Reverb Pan)
For setting the Reverb Effect Parameters.
• ChoCtgry (Chorus Category)
ChoType (Chorus Type)
ChoRtn (Chorus Return)
ChoPan (Chorus Pan)
For setting the Chorus Effect Parameters.
• ChoToRev (Chorus to Reverb)
For adjusting the Send Level from the Chorus Effect
to Reverb Effect.
Select the desired parameter for editing by using the
cursor [ ][ ] buttons and change the settings with the
data dial.
Press the [EFFECT] button to call up the Effect Edit
display. You can edit detailed parameters from this
display.
The PAGE [
EE
EE
][
FF
FF
] buttons can be used to switch
between effect types.
Select the desired parameter for editing by using the
cursor [ ][ ] buttons and change the settings with the
data dial.
n For information on the Effect Parameters, refer to the
separate Data List.
n If “thru” or “off” is selected for the effect type, none of
the effect parameters can be edited.
The MOTIF-RACK has two types of equalization:
independent three-band equalizers for each Part and a
five-band equalizer that is applied to all Parts. These
are edited in the Multi Edit mode (page 45).
n For details about the equalizers, see page 22.
First, set the Part Equalizer settings in the EQ display
in the Multi Part Edit (page 46).
Then, set the Master Equalizer settings in the MEQ
display in the Multi Common Edit (page 45).
n For details about each parameter, refer to the reference
section.
If you wish to save the new settings, store the settings
with the other Multi parameters as a single Multi
before you leave the selected Multi. For details about
storing Multis, see page 57.
n If you call up another Multi or another mode without
saving, the edited settings may be lost.
6
Set the System Effect parameters
(Reverb, Chorus) (page 49, ).
7
Set the detailed effect parameters
as necessary.
B
Effect Type (Rev, Cho)
8
Set the Equalizer parameters (page
49, and ).
9
Store the edited Multi.
C
D