Filter
Top Products
10 SPX2000—Owner’s Manual
Operation
Basic operation
This section provides a simple explanation of how to input signals to the SPX2000,
apply effects, and output the result. The overall steps are as follows.
Make connections to external devices
↓
Turn the power on
↓
Select the input signal
↓
Select an effect
↓
Recall the effect
↓
Switch the effect on/off
The connectors you use will depend on whether the input/
output signals are analog or digital.
• Analog input:
Connect your device to the [INPUT] jacks ([).
• Digital input:
Connect your device to the [AES/EBU IN] jack (X).
• Analog output:
Connect your device to the [OUTPUT] jacks (Y).
• Digital output:
Connect your device to the [AES/EBU OUT] jack (W).
Related items
• Selecting the word clock source......................... page 18
•Using your computer to
control the SPX2000 ............................................page 6
•Using MIDI messages to
control the SPX2000 .........................................page 88
Here’s how to turn on the power of a system that includes
the SPX2000.
1 Protect your monitor system
Before you turn on the power of the SPX2000, turn off
the power of the device that is connected to the [OUT-
PUT] jacks (Y) or [AES/EBU OUT] jack (W). Also
turn the [INPUT L R] control (1) to minimize the
L/R input signal level (the inner knob controls the L
channel, and the outer knob controls the R channel).
2 Turn on the power of the SPX2000
Press the [POWER ON/OFF] button (P) to turn the
power on.
→ The front panel display and LEDs will light.
3 Turn on your external devices
Turn on the power of devices connected to the
SPX2000.
Make connections to external
devices
NOTE: If you are inputting/outputting analog signals, you must
set the [INPUT –10 dBu/+4 dBu] switch (
\
) and the [OUTPUT
–10dBu/+4dBu] switch (
Z
) appropriately for the signal level of
the connected devices.
You must turn off the power of all devices before you
make connections.
Turn the power on
NOTE:To prevent high-volume noise from being out-
put from your speakers, turn on the power starting
with the device that is closest to the audio source.
Example: sound modules → mixer → SPX2000 →
power amp
Reverse this order when turning the power off.