Filter
Top Products
SPX2000—Owner’s Manual 9
Rear panel
Q Grounding screw
For safety, use this screw to ground the SPX2000.
The included power cable has a three-prong plug; if the
electrical outlet you use is correctly grounded, the
SPX2000 will be appropriately grounded. If the electri-
cal outlet is not grounded, use this screw to ground the
SPX2000. Correctly grounding the SPX2000 will effec-
tively reduce hum and interference.
R [AC IN] jack
Connect the power cable to this jack. First connect the
power cable to the SPX2000, and then connect the
other end to the electrical outlet.
S [MIDI OUT/THRU] connector
You can connect a MIDI device to this connector and
use MIDI messages to send SPX2000 data to it. You can
bulk-dump SPX2000 data via MIDI, or re-transmit
MIDI data received at the [MIDI IN] connector (T)
from this connector without change. Use “MIDI OUT
SETUP” (page 21) to specify whether this connector
functions as “MIDI OUT” or “MIDI THRU.”
T [MIDI IN] connector
You can connect a MIDI device to this connector and
use messages transmitted from that device to remotely
control the SPX2000 (page 88).
U [TO HOST USB] connector
You can use a USB cable to connect your computer
here. You can use SPX2000 Editor or your MIDI appli-
cation to remotely control the SPX2000 from your
computer (page 6).
V [WORD CLOCK IN] jack
Connect this jack to a device that supplies a word clock
signal. This jack is terminated with a 75-ohm resistor.
Connect this jack in a one-to-one connection with the
device supplying the word clock.
W [AES/EBU OUT] jack
Connect an AES/EBU format device to this jack. This
XLR-3-32 jack outputs an AES/EBU format digital sig-
nal.
X [AES/EBU IN] jack
Connect an AES/EBU format device to this jack. This
XLR-3-31 jack inputs an AES/EBU format digital sig-
nal.
Y [OUTPUT] jacks
Connect these jacks to the effect return of your mixer
or to the input of your power amp. These jacks output
analog signals. Use either the XLR-3-32 jacks or the
TRS phone jacks, as appropriate for the device you are
connecting.
Z [OUTPUT –10 dBu/+4 dBu] switch
Set this to either –10 dBu or +4 dBu according to the
input level of the device connected to the [OUTPUT]
jacks (Y).
[ [INPUT] jacks
Connect these jacks to the effect send of your mixer or
to the output of an electronic musical instrument.
These jacks input analog signals. Use either the XLR-3-
31 jacks or the TRS phone jacks, as appropriate for the
device you are connecting.
In order to enable these jacks, you must set the input
source setting to “ANALOG” (page 19).
\ [INPUT –10 dBu/+4 dBu] switch
Set this to either –10 dBu or +4 dBu according to the
output level of the device connected to the [INPUT]
jacks ([).
R S T W XYU V
ZQ \
[
Use only the supplied power cord.